This is the ideal cooling solution for small aquariums--55
gallons or less. It is a quiet, reliable & efficient chiller uses advanced
thermoelectric tech- nology to directly convert electricity into cooling power.
Can be easily bulk- headed through a 1 1 4/" hole into siphon overflows,
prefilters, sumps or even directly into plastic aquariums. Provides continuous
chilling when plugged in to a power source, it does not have an on/off switch. A
separate temperature controller must be used to turn the device on or off at
pre-determined tempera- tures. Size: 4" x 4 3/4" x 7 1/2" includes probe. Item Number: WK0001
This is the ideal cooling solution for small aquariums--55 gallons or less. This
quiet, reliable & efficient chiller uses advanced thermoelectric technology to
directly convert electricity into cooling power.
Can be easily bulkheaded through a 1 1/4" hole into siphon overflows, prefilters,
sumps or even directly into plastic aquariums.
Provides continuous chilling when plugged in to a power source, it does not have
a on/off switch.
A separate temperature controller must be used to turn the device on or off at
pre-determined tempertures.
Instructions:
Locate the position(s) where you intend to bulkhead the chiller before drilling
any holes. If you intend to install multiple units in a single sump/prefilter/aquarium,
ensure that the units are spaced so that the heat sinks do not contact each
other.
The chiller uses a fan to dissapate heat created during the cooling process, so
it is very important to have proper ventilation. If not, the system will not
function properly and could be permanently disabled by the system's built in
safety feature.
To achieve a watertight bulkhead installation: drill a 1 1/4" diameter hole into
your sump/prefilter/aquarium. Remove the white nylon nut from the threaded
probe. Insert the probe through the hole with the clear silicon washer on the
outside (dry side) of the reservoir wall. Tighten the nylon nut on the threaded
probe.
The probe can be inserted through the top, side or bottom of a reservoir and
will function properly provided that there is adequate venitaltion around the
fan motor.
Size:
Unit is 4" x 4 3/4" x 7 1/2" includes probe. Cord: 5' 9", probe cord: 6'.
Warranty:
Unit has a one year warrenty agains defects in materials and workmanship.
