The Prop Pump with Magnet Mount makes aquarium circulation a breeze.Magnet mount design lets you place it exactly where you require: without having to deal with annoying suction cups. High volume, low pressure design is optimized for energy efficiency. 160 degree directional discharge lets you set the pump exactly where your tank requires flow. Ceramic shaft and rotor bearings. UL Listed. Cannot be used with a wavemaker. SEIO P320 Prop Pumps have a maximum flow rate of 320 GPH, and the magnet mount can be applied to glass up to 1/4 in. thick. Pump has a 6 ft. power cord.
Specifications Overall Dimensions 1.9 IN. X 1.5 IN. X 2.5 IN.
Application CIRCULATION ONLY
Maximum Flow Rate 320 GPH
Watts 4 1/2
Instructions Installation: Submerse pump in water and secure in desired location. Plug pump into a GFCI (Ground Fault Circuit Interrupter) electrical outlet. If there is too much flow, unplug the pump and remove the large Intake Strainer and adjust flow accordingly. Reassemble and plug back into the GFCI electrical outlet. The flow can be directed to a different location be rotating the 120� Directional Discharge. To use the Venturi Control, rotate counterclockwise. When using the Venturi Control, the use of an Air Silencer is recommended. Maintenance: Routine weekly maintenance is of the utmost importance to ensure a well-operating pump. Unplug the pump from the GFCI electrical outlet. Remove the large Intake Strainer. Remove the 120� Directional Discharge. Remove the Impeller Well Lock and Impeller Well Cover. Remove the Turbine Impeller and Ceramic Shaft. Clean the inside of the Impeller Well with a small brush. Remove the bearings and slide the Ceramic Shaft from the Turbine Impeller. Clean the shaft with 50% water and 50% vinegar solution, letting it soak for 15 minutes. Reassemble. Clean the Intake Slots on the pump and large Intake Strainer in the Flow Control. Reassemble and install pump. NOTE: When assembled, the impeller should spin freely on the shaft. Verify that that bearings and two rubber end caps are replaced on the end of the shaft.
Warranty Pump has a 6 month warranty against defects in materials and workmanship.
